Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)09 · 55 Electrical system
09 · Electrical

55D.

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Connectors › 55D.
55 Electrical system55D. · page 1 of 2

55D.

The rev counter is not working

  1. Bridge the L coloured cable between the instrument panel 6 connector A pin 16 and the fuel injection control unit 160 pin 3 (195 pin 42 for 1581, 190 pin 6 for 1998)
    1. OK → Restore the continuity for the L coloured cable between the instrument panel 6 connector A & the electronic injection control unit
    2. Not OK → Connect to diagnostic socket 139 (See electronic injection wiring diagram) and carry out fault diagnosis with the Fiat Lancia Tester

The speedometer is not working

  1. Bridge the N coloured cable at the vehicle speed sensor 137 with an earth (if there are also problems with the electronic injection control unit sensor 137)
    1. OK → Restore the continuity of the N coloured cable between the sensor 137 & the right front earth 9
    2. Not OK → Check for voltage at the CN coloured cable for the instrument panel 6 connector A pin 15 (if there are also problems with the electronic injection control unit sensor 137)
      1. Not OK → Overhaul the instrument panel 6
      2. OK → Check for voltage at the CN coloured cable for connector 55
        1. Not OK → Restore continuity for the CN coloured cable between connector 55 & the instrument panel 6 connector A

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.