Flat CODE (page 3 of 3)

When the CODE warning light goes out, turn the key (2) to the ignition off (STOP) position.

Within 10 seconds:

• withdraw the keky (2) from the ignition switch block;
• insert the MASTER key in the ignition switch block again and turn it to the ON position (+15); the CODE warning light comes on for 0.7 s.

When the CODE warning light goes out, turn the MASTER key to the off (STOP) position.

The memorization procedure is completed (memorization of the Master Code in the engine control unit) as follows:

• turn the MASTER key to the ignition on (+15) position;
• keep the MASTER key at the ON position for about 3 seconds;
• the CODE warning light comes on for 0.7 s and goes out definitively if the procedure has been successful (positive result);
• the CODE warning light comes on for 0.7 s and starts flashing again after about 2 seconds if the memorization has NOT been successful (negative result). In this case, withdraw the MASTER key and repeat the key memorization procedure from the beginning.

Also refer to the diagram on the next page.