Replacing front pillar (7090g 30)*

REPLACING FRONT PILLAR (7090G 30)*

(*) This number indicates the operation code given in the Flat rate manual.

The component for which the replacement procedure is given is highlighted in the diagram at the side.

PRELIMINARY PROCEDURES

Establish the extent of the damage, check if there are distortions to the connected components by checking the bodyshell alignment figures, using suitable methods (jigs, templates or gauges).

Carry out any straightening operations required to the bodyshell before cutting the component. After this operation check that the components not being replaced are intact.

PRELIMINARY DISMANTLING

Remove the moving parts of the bodywork and interior fittings, which could impede the repair operations or be damaged during them.

REMOVING

Cut the vehicle front pillar using a power saw following the dotted lines shown in the diagram below.

The most important sections of the body panel are shown in order to allow the operator to adjust the position and the depth of the cutting so as not to damage the panels underneath.

When carrying out the operations described, adhere strictly to the safety procedures. Protective shoes, ear-muffs and gloves should be worn during the cutting operations, welding masks and gloves during the welding operations, and a protective mask and gloves during the painting operations.