Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)10 · 70 Bodywork
10 · Body & interior

Bodywork operations

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Seat belt pretensioner › Bodywork operations
70 BodyworkBodywork operations
Diagram of a seat belt pre-tensioner unit with four prohibition symbols indicating it must not be exposed to water, mud, oil, or temperatures exceeding 110°C

If on account of exceptional atmospheric conditions (floods, sea-storms etc.) the water and mud reaches such a height that the device components are affected, it must be replaced. The pre-tensioner is maintenance-free and should definitely not be lubricated. Any modifications invalidate its efficiency.

Bodywork operations

G. Do not subject the area surrounding the pre-tensioner (60-70 cm radius) to great impacts due to bodywork repairs (for example the use of a hammer; if necessary, remove the complete pre-tensioner unit. If it is necessary to use heating lamps on the paintwork in the area surrounding the pre-tensioner or to carry out welding or brazing, then the complete pre-tensioner reel assembly has to be removed.

Top-down diagram of a car showing the 60-70 cm radius areas surrounding the front seat belt pre-tensioners that must be protected from impacts

If a vehicle with one or more pre-tensioners has to be moved, then they should be placed in the luggage compartment and not in the passenger compartment which is forbidden. A pre-tensioner which has not been activated in the case of an accident should be considered still active; therefore if they have not exploded because they are defective or have reached the end of their warranty or for other reasons, they should be replaced and returned (the complete device) to the special Centre following the same procedure as described for Air Bag modules (see section 55 - Electrical equipment).

Ordering instructions

Follow the same procedures already described for ordering Air Bag modules (see section 55 - Electrical equipment).

NOTE Pre-tensioners have been specially designed to be fitted on each individual type and marque of vehicle on account of which they cannot be adapted, reused or fitted on other vehicles, but only on those for which they were designed and produced. Any attempts to reuse, adapt or fit pre-tensioners on different types of vehicles could cause serious or fatal injuries to the occupants of the vehicle both in the case of an accident or in the case of normal usage. After being fitted the pre-tensioner bracket can be activated if it receives an impact of sufficient force.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.