Removing bracket

REMOVING BRACKET

The removal of the bracket (3 in the diagram overleaf) prevents the pyrotechnic device from accidentally being activated. This operation should be carried out each time a service operation which may cause the accidental activation of the device is carried out. The bracket should ALWAYS ONLY BE REFITTED with the pre-tensioner unit fitted on the vehicle in order to prevent injury to the personnel carrying out the operation

3 door version

(A) Direction of travel

Break the protective collar (5) (guarantee seal), undo the fixing bolt (4) and remove the bracket (3) (also see diagram at the top of the page overleaf).

Undo the bolt (2) which fixes the pre-tensioner (1) to the bodyshell and extract the pre-tensioner from inside the pillar.

5 door version

(A) Direction of travel

Break the protective collar (5) (guarantee seal), undo the fixing bolt (4) and remove the bracket (3) (see diagram atthe foot of the page overleaf).

Undo the bolts (2) fixing the pre-tensioner support to the bodyshell and remove the support (6) assembly and the pre-tensioner (1) from the pillar and separate the two components.