Engine oil vapour intake pipe - r + r
- Make
- Fiat
- Model
- Doblò Factory Service Manual
- Year
- 2000–2010
- Section
- Emission control system › Engine oil vapour intake pipe - r + r
Engine oil vapour intake pipe - r + r
Removing
Op. 1048A10 AIR FILTER ASSEMBLY - R.R.
1. Remove retaining bands (1a) and disconnect the breather pipe from cam cover (1b) and from air intake manifold (1c).
Refitting
Fit the pipe and connect it to the breather on the cam cover. Secure with a retaining collar.
Connect the pipe to the intake manifold.
Op. 1048A10 AIR FILTER ASSEMBLY - R.R.
Removing
Position the vehicle on a lift.
Disconnect the negative battery terminal.
| Description | Connector | |
|---|---|---|
| Battery | See A001 BATTERY |
Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R.R.
Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.
Raise the vehicle on the lift.
1. Open collar (1a) and disconnect oil vapour recovery pipe (1b), then lower the vehicle.
1. Remove the engine oil vapour recovery pipe by removing from the engine compartment.
Refitting
Refit the engine oil recovery pipe and secure it using the bands.
Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R.R.
Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R.
Connect the negative battery terminal.
| Description | Connector | |
|---|---|---|
| Battery | See A001 BATTERY |
Remove the vehicle from the lift.
Removing
Position the vehicle on a lift.
Proceed with the removal
Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R..
1. Loosen the collar and disconnect the engine oil vapour inlet pipe from the T-connector.
1. Loosen the collar and disconnect the engine oil vapour inlet pipe from the cam cover and remove.
Refitting
Refit the oil vapour inlet pipe in its seat and connect to the cam cover and secure with the relevant band.
Connect the engine oil vapour intake pipe to the T-connector and tighten the collar.
Proceed with the refitting
Op. 7055B54 PROTECTION/GUARD UNDER ENGINE - R.R..
Remove the vehicle from the lift.
Removing
Op. 1048A10 AIR FILTER ASSEMBLY - R.R.
1. Loosen collar (1a) and remove the engine oil vapour inlet pipe (1b) from the air filter.
Refitting
- Refit the oil vapour inlet pipe in its seat and connect to the air filter with the relevant band.
Parts & tools for this job For 2000 Fiat Doblò
- PARTEngine gasket setSearch: Fiat Doblò 2000 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.