Engine oil collection MANIFOLD - R.R.

Operation 1080D35 · Crankcase vapour/gas recirculation system

Removing

Position the car on the ramp.

Make sure that the ignition is OFF, then loosen the bolt and disconnect the battery negative terminal.

Carry out - 4450B04 right front wheel r r.

Carry out.

Carry out - 1092C10 power steering and/or self-levelling suspension pump drive belt - r + r.

Carry out - 1092G10 single engine belt r r.

Carry out - 5530A10 alternator - r+r.

Carry out.

Disconnect the electrical connections from the starter motor and move them aside.

1. Loosen the band and disconnect the engine oil recovery pipe, engine oil recovery manifold side.

2. Undo the bolts (2a) and remove the engine oil recovery manifold (2b) complete with gaskets (2c).

Refitting

Refit in its seating the engine oil recovery manifold complete with gaskets and secure it with the bolts.

Connect the engine oil recovery pipe, engine oil recovery manifold side, and tighten the band.

Connect the electrical connections to the starter motor.

Carry out.

Carry out - 5530A10 alternator - r+r.

Carry out - 1092G10 single engine belt r r.

Carry out - 1092C10 power steering and/or self-levelling suspension pump drive belt - r + r.

Carry out.

Carry out - 4450B04 right front wheel r r.

Connect the battery negative terminal.

Remove the vehicle from the ramp.