Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Doblò Factory Service Manual (2000-2010)19 · Wiring diagrams and electrical functions
19 · Electrical

Reversing lights - description

Make
Fiat
Model
Doblò Factory Service Manual
Year
2000–2010
Section
Exterior lighting › Reversing lights - description
Wiring diagrams and electrical functionsReversing lights - description

REVERSING LIGHTS - DESCRIPTION

1.2 8v, 1.6 16v, 1.3 JTD 16V, 1.9 JTD 8V, 1.9 DIESEL · from 10/2000, up to 10/2000

Description

The vehicle is equipped with a reversing light located in the rear lights.

They are operated each time reverse gear is engaged through the special switch on the outside of the gearbox casing.

The circuit is supplied with the ignition switched ON and is protected by a fuse, in the junction unit under the facia.

1.2 8v, 1.6 16v, 1.3 JTD 16V, 1.9 JTD 8V, 1.9 DIESEL · from 12/03

Description

The vehicle is equipped with a reversing light located in the rear lights.

They are operated each time reverse gear is engaged through the special switch on the outside of the gearbox casing.

The circuit is supplied with the ignition switched ON and is protected by a fuse, in the junction unit under the facia.

The signal that the reversing light has been switched on is managed by the Body Computer which forwards this information to the parking sensor control unit (

See E3090 PARKING SENSOR

) and to the radio navigator (

See E4090 NAVIGATOR

).

1.4 8v, 1.6 16v, 1.3 JTD 16V, 1.9 JTD 8V · from 12/03 · MY 2005

The vehicle is equipped with reversing lights located in the tail-light clusters.

These are operated whenever reverse is engaged via a switch on the outside of the gear housing.

The circuit is supplied with the key on MAR and protected by a fuse located in the underfacia junction unit.

The reversing light activation signal is managed by the Body Computer, which forwards this information:

- to the Parking Sensor Control Unit;

See E3090 PARKING SENSOR

- and to the Radio Navigation System;

See E4090 NAVIGATOR

- while also inhibiting the seat belt buzzer.

See E7030 AIRBAG

Parts & tools for this job For 2000 Fiat Doblò

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.