FRONT CRANK SHAFT COVER OIL SEAL - REPLACE

Operation 1020D18 · OIL SEALS ON CRANK SHAFT

2.3 JTD 16V

Removing

Op. 7055B54 UNDER-ENGINE GUARD - R R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 1092B72 POWER STEERING PUMP DRIVE BELT - ALTERNATOR - R&R

See in Op. 1092A10

See in Op. 1032D12

See in Op. 1032B10

See in Op. 1032B44

1. Use the tool described below to fit the oil sealing ring.

2. Position the tool extraction pincers (2a) into oil sealing ring grooves (2b).

3. Secure the extraction pincers in position using retaining bolts.

4. Tighten the tool pin to remove the oil sealing ring from its seat.

Because the oil seal must always be replaced, it may be destroyed when it is removed.

Refitting

1. Use the tool described below to fit the oil sealing ring.

1. Tighten the threaded tool pin until it comes into contact with the crankshaft drive gear seat.

- Position the new oil sealing ring in its seat

3. Position introduction tool (3a) in contact with the oil sealing ring and tighten into nut (3b) to fully fit the oil sealing ring into its seat on the front cover.

See in Op. 1032B44

See in Op. 1032B10

See in Op. 1032D12

See in Op. 1092A10

Op. 1092B72 POWER STEERING PUMP DRIVE BELT - ALTERNATOR - R&R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 0010T11 ENGINE OIL CHECK LEVEL AND TOP UP

Op. 7055B54 UNDER-ENGINE GUARD - R R

2.0 JTD 8V

Removing

Op. 7055B54 UNDER-ENGINE GUARD - R R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 1092G10 SINGLE ENGINE BELT R R

See in Op. 1092A10

See in Op. 1032D12

See in Op. 1032B10

See in Op. 1032B44

- Remove the oil seal from the housing in the front cover.

Because the oil seal must always be replaced, it may be destroyed when it is removed.

Refitting

1. Fit the oil seal (1a) using the tool (1b) in the housing in the crankshaft front cover.

See in Op. 1032B44

See in Op. 1032B10

See in Op. 1032D12

See in Op. 1092A10

Op. 1092G10 SINGLE ENGINE BELT R R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 0010T11 ENGINE OIL CHECK LEVEL AND TOP UP

Op. 7055B54 UNDER-ENGINE GUARD - R R