OIL DIP STICK PIPE - R R

Operation 1084A16 · INDICATORS/CHECK DEVICES

2.3 JTD 16V

Removing

1. Remove the air delivery sleeve to the air-air heat exchanger (intercooler).

1. Undo the bolts securing the power steering fluid reservoir bracket.

2. Disconnect the oil pipes from the reservoir.

3. Remove the power steering fluid reservoir complete with bracket.

- Seal both pipes with plugs.

1. Remove the second section of the air delivery sleeve to the air-air heat exchanger (intercooler).

1. Disconnect the electrical connection of the right front light cluster.

2. Disconnect the collars at both ends and remove the air pipe from intercooler to intake manifold.

1. Undo retaining bolt (1a) and remove the engine oil dipstick (1b).

Refitting

- Fit the engine oil dipstick pipe and tightenn the retaining bolt.

- Fit the air pipe from intercooler to intake manifold and connect the collars to both ends.

- Connect the electrical connection of the right front light cluster.

- Fit the second section of the air delivery sleeve to the air-air heat exchanger (intercooler).

- Fit the power steering fluid reservoir complete with bracket.

- Connect the fluid pipes to the reservoir and tighten the power steering system fluid reservoir bracket bolts.

- Fit the air delivery sleeve to the air-air heat exchanger (intercooler).

- Fill the power steering system with appropriate fluid.

2.8 JTD 8V

Removing

See in Op. 1048B14

See in Op. 1048B22

1. Undo the fixing bolts.

2. Remove the oil dipstick pipe and move the brackets on the fastenings aside.

Refitting

- Position the engine oil dipstick pipe in its housing.

- Position the brackets on the fastenings.

- Tighten the fixing bolts.

See in Op. 1048B22

See in Op. 1048B14

2.0 JTD 8V

Removing

See in Op. 1060F50

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Position a container underneath the engine to collect the engine oil.

1. Undo the drain plug in the crankcase sump and leave the oil to drain into the container.

Be very careful when removing the drain plug; the oil could be very hot.

Do not let the oil disperse into the atmosphere as this could cause pollution.

1. Undo the engine oil dipstick pipe upper fixing bolts.

- Raise the lift.

2. Undo the lower bolt (2a) and remove the engine oil dipstick pipe (2b).

Refitting

- Fit the engine oil dipstick pipe.

- Tighten the engine oil dipstick pipe lower fixing bolt to torque.

- Lower the lift.

- Tighten the engine oil dipstick pipe upper fixing bolts to torque.

- Clean the drain plug and tighten it to the recommended torque.

- Lubricate the new oil filter seal with engine oil and tighten it fully.

- Refill the lubrication circuit with the recommended oil.

Op. 7055B54 UNDER-ENGINE GUARD - R R

See in Op. 1060F50