CRANKSHAFT SERVICES PULLEY - R.R.

Operation 1092A10 · CRANKSHAFT PULLEY AND IDLE PULLEYS

2.0 JTD 8V

Removing

- Position the vehicle on a lift.

Op. 7055B54 UNDER-ENGINE GUARD - R R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 1092G10 SINGLE ENGINE BELT R R

- Disconnect the electrical connection for the rpm sensor.

1. Undo the fixing bolt.

2. Remove the rpm sensor.

1. Fit the flywheel lock in the housing for the rpm sensor.

1. Undo the fixing bolts (1a) and remove the auxiliary shaft drive pulley (1b).

Refitting

- Fit the auxiliary shaft drive pulley and tighten the fixing bolt to torque using the angular tightening tool.

- Remove the flywheel lock fitted previously.

- Fit the rpm sensor in the housing on the bellhousing and tighten the fixing bolt.

- Connect the electrical connection for the rpm sensor.

Op. 1092G10 SINGLE ENGINE BELT R R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Remove the vehicle from the lift.

2.3 JTD 16V

Removing

- Position the vehicle on a lift.

Op. 7055B54 UNDER-ENGINE GUARD - R R

Op. 4450B04 RIGHT FRONT WHEEL R R

- Slacken the engine component pulley retaining bolts before removing the auxiliary drivebelt.

Op. 1092B72 POWER STEERING PUMP DRIVE BELT - ALTERNATOR - R&R

1. Undo the retaining bolts.

2. Remove the auxiliary drivebelt pulley.

Refitting

- Fit the auxiliary drivebelt pulley.

- Tighten the bolts securing the crankshaft pulley to the recommended torque.

Op. 1092B72 POWER STEERING PUMP DRIVE BELT - ALTERNATOR - R&R

Op. 4450B04 RIGHT FRONT WHEEL R R

Op. 7055B54 UNDER-ENGINE GUARD - R R

- Remove the vehicle from the lift.