3. Checking (page 6 of 6)

Figure : B1EG0YQD

Refit the ring seal (4) (Fitted with its fitting cone).

Engage the ring seal (4) in the timing cover (6).

Remove the fitting cone from the ring seal (4).

Turn through 1/4 of a turn clockwise to lock the ring seal (4); Using tool [0198-D].

CAUTION : Superimpose the upper engine mounting on the intermediate engine mounting, in order to line up the holes; Using a workshop jack under the oil sump.

Refit :

• The intermediate engine mounting (2)
• The engine top mounting (3)

Remove the transverse engine support bar.

Refit :

• The power steering fluid reservoir and expansion bottle assembly (1)
• The air filter housing
• The alternator and air conditioning compressor drive belt guide rollers Check the electrical operation of the equipment
• The accessory belts (according to equipment)
• The headlamps
• The front right mud guard
• The protection plates under the engine (RH side)
• The front right wheel

Return the vehicle to its wheels.

Tighten the wheel bolts.

CAUTION : Perform the operations to be carried out following reconnection of the battery.