Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Idea Factory Service Manual (2003-2012)17 · Body fittings
17 · Body & interior

Rear panel - r r

Make
Fiat
Model
Idea Factory Service Manual
Year
2003–2012
Section
Bodyshell interior trims and fittings › Rear panel - r r
Body fittingsRear panel - r r

Rear panel - r r

Operation 7040H50 · Roof panel lining

Removing

- 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

- 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. (alternatively)

1. Undo the bolt.

2. Remove the trim (2a) by undoing retaining clip (2b) with the the appropriate tool.

NameCountry
2Scraper blade1.878.077.000
Rear panel - r r

Refitting

Check that the cover is undamaged.

Position the trim by doing up the retaining clip.

Tighten the bolt.

- 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

- 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R. (alternatively)

Parts & tools for this job For 2003 Fiat Idea

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.