Operating cylinder/clutch hydraulic actuator - r.r.
- Make
- Fiat
- Model
- Idea Factory Service Manual
- Year
- 2003–2012
- Section
- Clutch release controls › Operating cylinder/clutch hydraulic actuator - r.r.
OPERATING CYLINDER/CLUTCH HYDRAULIC ACTUATOR - R.R.
Removing
Proceed with removal - 5530B10 battery - r+r
Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.
1. Remove the cap on the bleed valve.
2. Connect the collection system (pipe and reservoir) to the bleed valve on the clutch operating cylinder.
3. Loosen the bleed screw and let the hydraulic clutch system drain completely.
4. Lift the retaining clip (4a) and disconnect the pipe from the master cylinder to the clutch operating cylinder (4b), operating cylinder side.
5. Undo the bolts (5a) and remove the clutch operating cylinder (5b).
Removing
Proceed with removal - 5530B10 battery - r+r
Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.
1. Remove the cap on the bleed valve.
2. Connect the collection system (pipe and reservoir) to the bleed valve on the clutch operating cylinder.
3. Loosen the bleed screw and let the hydraulic clutch system drain completely.
4. Lift the retaining clip (4a) and disconnect the pipe from the master cylinder to the clutch operating cylinder (4b), operating cylinder side.
5. Undo the bolts (5a) and remove the clutch operating cylinder (5b).
Refitting
Replace the clutch operating cylinder, then fix it tightening the bolts to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | CLUTCH SLAVE CYLINDER | M8 | (Gearbox side) 1.8 - 2.2 |
Fit the pipe between the master cylinder and the clutch operating cylinder fully home in its seat on the clutch operating cylinder and secure with the retaining clip.
Proceed with refitting - 0010T64 brake and or clutch fluid check level and top up as necessary.
Proceed with refitting - 0010T67 hydraulic clutch system bleed air.
Proceed with refitting - 5530B52 Battery DRIP TRAY/SUPPORT - R.R..
Proceed with refitting - 5530B10 battery - r+r.
Refitting
Place the clutch operating cylinder (1a) back in its housing and secure it tightening the bolts (1b) to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | CLUTCH SLAVE CYLINDER | M8 | (Gearbox side) 1.8 - 2.2 |
Fit the pipe between the master cylinder and the clutch operating cylinder fully home in its seat on the clutch operating cylinder and secure with the retaining clip.
Proceed with refitting - 0010T64 brake and or clutch fluid check level and top up as necessary.
Proceed with refitting - 0010T67 hydraulic clutch system bleed air.
Proceed with refitting - 5530B52 Battery DRIP TRAY/SUPPORT - R.R..
Proceed with refitting - 5530B10 battery - r+r.
Parts & tools for this job For 2003 Fiat Idea
- PARTClutch kitSearch: Fiat Idea 2003 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Fiat Idea manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.