Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 21 Gearbox and differential04 33 Braking system05 41 Steering06 44 Suspension and wheels07 27 Axle and rear differential (4x4)08 24 Propeller shaft (4x4)09 55 Electrical system10 70 Bodywork
Fiat Panda (141) Factory Service Manual (1986-2003)06 · 44 Suspension and wheels
06 · Steering & suspension

Removing-refitting brake shoes

Make
Fiat
Model
Panda (141) Factory Service Manual
Year
1986–2003
Section
Rear suspension › Removing-refitting brake shoes
44 Suspension and wheelsRemoving-refitting brake shoes · page 1 of 2

Removing-refitting brake shoes

The millings on the hub shown by the arrow must be facing the self-adjusting device to allow the removal and refitting of the brake shoes.

A hand holding a brake shoe against a brake disc and hub assembly.

Removing-refitting wheel cylinder

A close-up view of a tool being used on the back of a brake backing plate to remove or adjust the wheel cylinder.

Removing wheel hub cap

Two hands using a long tool to pull a wheel hub cap (labelled 1847014000) off a shaft.

Parts & tools for this job For 1986 Fiat Panda

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.