Heater with manual controls

Heater with manual controls

- unscrew screw (11) that fastens connector (12) to left side support of distributor heater unit (13);

• disconnect connector (14) from resistor (15) and connector (16) from support (17) of fan (18);
• release electrical wiring cables from clips indicated by small arrows that retain them to the assembly;
• unscrew the screws indicated by large arrows in the various figures that fasten duct (19) to fan (20) and distributor heater unit (13).

DISMANTLING FAN UNIT

• unscrew screws (21) that fasten the two case halves (22 and 23) together to make up the fan unit;
• unscrew screws (24 and 25) that fasten support (17) of fan (18) and resistor (15) to bottom case half (23);