Refitting hood (page 2 of 3)

• open the hood halfway and connect the belts and steel tensioning cables, inserting the pin in its housing using a hammer and drift;

• bring the hood into the closed position;
• working from inside the vehicle, turn the hood locking handles to the closed position, then check that the hood and the upper edge of the front window are correctly aligned;

The reading should be between 5 and 9 mm.

• if this is not the case see page 34 for the adjustment of the front hood alignment;

• position the tensioning cable in its housing (see inset);
• insert the edge of the hood in the bodyshell channel;