Constructive data
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Repair procedures introduction › Constructive data
00 General information and technical dataConstructive data
Operating data, that are typical of the operation, are shown on proper tables which follow the phase in which the datum is called.
- Loosen the adjustment nut of the gear selection/clutch set.
- Install the tool under the hooking ball of the gear clutch cable.
| Name | Code | |
|---|---|---|
| 2 | Spacer | 1.800.000.000 |
- Connect the gear selection/clutch cables.
- Tighten the adjustment nut.
- Remove the spacer.
Data which are shown on this tabulation are:
CONSTRUCTIVE DATA
| Measureme | Valoue | |
|---|---|---|
| - | TDC and rpm sensor coil resistance (Ω) | a 20°C 2300 ÷ 2600 |
TIGHTENING TORQUES
| Fixing | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| - | Bolt power steering box side | Steering unit shaft universal joint | M8 | 1.9 ÷ 2.1 |
PRODUCTS
| Type | Comp. | Name | Classificat. | Q.ty | |
|---|---|---|---|---|---|
| - | Oil (l) | Power steering system | TUTELA GI/A | G.M. DEXRON II | - |
SPECIAL TOOLS
| Name | Code | |
|---|---|---|
| 1 | Removing cutter | 1.878.077.00 |
ELECTRICAL COMPONENTS
| Name | Code | |
|---|---|---|
| - | TDC and rpm sensor | K45 |
The indication of the electric part code enables a navigation towards the part "Wiring diagrams" where there is a chapter "Part catalogue" that, following the code,sends to the concerned functions.
The operational data symbology (Constructive data, Driving torques, etc.) is also used on figures so as to find the parts which are associated with these data.
Parts & tools for this job For 1998 Fiat Seicento
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.