Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)02 · 10 Engine
02 · Engine

Refitting (page 3 of 3)

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Cylinder head (1108)
10 EngineRefitting · page 3 of 3

(Cont. Op. 1016C11)

Name Connector
Throttle position sensor K56
  • Connect the earth cable on the engine
Name Connector
Earth on engine C40
  • Connect the ignition coils electrical connections
Name Connector
Ignition coil
N° 1 (cyl. 1-4)		 A30
Ignition coil
N° 2 (cyl. 2-3)		 A30
  • Fit the coil protection.
  • Connect the coolant sleeve to the thermostat.
  • Connect the coolant pipe to the intake manifold.
  • Connect the vacuum intake pipe to the brake servo.
  • Connect the coolant pipes to the throttle case.
  • Connect the vacuum intake pipe to the fuel vapours on-off solenoid valve.
  • Connect the fuel recirculation pipe to the injector holder pillar.
  • Connect the fuel inlet pipe to the injector carrier turret.
  • Connect the accelerator control flexible pipe to the throttle case.
  • Mount the air cleaner thermostat device with the dashpot.
  • Connect the hot air intake sleeve to the exhaust manifold.
  • Connect the oil vapours recirculation pipe to the tappet cover.
  • Complete with Op. 1048A10 COMPLETE AIR CLEANER - R+R.
  • Connect the lower engine coolant sleeve to the radiator.
  • Fill the engine cooling system with coolant
Type Component Name Qty
Coolant (I) ENGINE COOLING SYSTEM Paraflu11 4.0
  • Screw on the engine cooling circuit breather plug.
  • Complete with Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R.
  • Complete with Op. 4450B10 FRONT WHEEL (one - R.R.
  • Connect the negative (-) battery terminal
Name Connector
Battery A1
  • Remove the body protection cover.
  • Remove the vehicle from the hoist.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.