Refitting (page 2 of 2)
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Timing system (899)
10 EngineRefitting · page 2 of 2
(Cont. Op. 1036A20)
- Assemble the front right wheel (see Op. 4450B10 WHEEL (one) front - R+R).
- Lower the vehicle.
- Insert the rocker arm control rods.
- Reposition the rocker arm carrier shaft with the supports, rocker arms and hydraulic tappets.
- Tighten the rocker arm carrier shaft support screws to correct torque
| Fastening | Component | Ø | Value (daNm) |
|---|---|---|---|
| - Nut | ROCKER ARM CARRIER SHAFT SUPPORT | M10 | 3.9 |
- Complete with Op. 1016A22 TAPPET COVER with supply duct - R+R and replace gasket.
- Complete with Op. 1068A10 ACCELERATOR PEDAL CONTROL - Check, adjustment if necessary and lubrication.
- Connect the negative (-) battery terminal
| Name | Connector |
|---|---|
| - Battery | A1 |
- Remove the body protection cover.
- Close the engine compartment.
- Remove the vehicle from the hoist.
Parts & tools for this job For 1998 Fiat Seicento
- PARTEngine gasket setSearch: Fiat Seicento 1998 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.