Reassembly

(Op. 4120A14 continued)

1. Separate the adjustable track rod articulated joints from the front hub uprights using the tool

[1108] [899]

1. Slacken the screws (1a) fastening the steering box (1b) and remove it.

• Carry out Op. 4110B14 Steering TRACK RODS - R+R. with steering box removed.

Reassembly

• Complete with Op. 4110B14 Steering TRACK RODS - R+R. with steering box removed.
• Re-position the steering box and temporarily tighten the fastening screws a little.
• Lower the vehicle.
• Insert the steering shaft joint on the steering box pinion in accordance with the position marked during removal.
• Raise the car.

1. Tighten the screws (1a) fastening the steering box (1b) to the specified torque

[1108]

• Connect the adjustable track rod articulated joints to the front hub uprights and tighten the fastening nuts to the specified torque

[1108] [899]

• Lower the vehicle.
• Assemble the screw of the steering shaft joint fastening part and tighten the locknut.

The screw of the steering shaft joint fastening piece must slot into the groove on the steering box pinion.

• Complete with Op. 4110A40 Ateering shaft JOINTS - Locking screws.

Note: Front wheel toe-in must be checked each time the steering box is removed/refitted.

4120A20 - STEERING BOX, REMOVED - DISASSEMBLY AND REASSEMBLY - WASHING, CHECKING & REPLACING PARTS

Disassembly

• Place the steering box in a vice.
• Remove the steering box boots (refer to Op. 4120A30 Steering box BOOT (one) lh or rh - Re-pl. on bench).

(Cont.d)