5505c41 - passenger compartment integrated wiring - r.r.

(Cont. Op. 5505C40)

1. Lay the wiring in the vehicle and fasten it with the retainer pegs.
2. Slide the handbrake switch wire under the tunnel mat and connect the electric connections.
3. With the probe in position from the previous operation, lay the feed pump wiring and position the rubber chock.
4. Slide the wiring to the rear part through the chock.

• Connect the electric connection to the feed pump and fit the cover back fastening the four screws.
• Slide the wiring out from the rear crossmember and fasten it to the wheelhouse with three new clips.
• Reposition the wiring and rear light cluster connectors and sliding contacts on the rear crossmember.

1. Slide the wiring with number plate light connections and earth point through the rubber chock and fasten with a new clip.
2. Connect the earth node and fasten the screw.
3. Fasten the wiring to the retainer pegs.

• Refit the sliding contacts, refer to Op. 5505A21 - RIGHT-HAND SLIDING CONTACT SUPPORT - R. R. and Op. 5505A23 - LEFT-HAND CONTACT SUPPORT - R. R.
• Reposition the mat and screw the rear fastening buttons.
• Refit the lower seat belt anchoring, refit the fastening screw and the cover cap.

5505C41 - PASSENGER COMPARTMENT INTEGRATED WIRING - R.R.

Removal

• Perform Op. 7040A10 - INSTRUMENT PANEL TRIM - R.R.
• Perform Op. 4110A11 - STEERING WHEEL - r.r for replacement or checks for versions with airbag.
• Perform Op. 5580C18 - AIRBAG UNIT - r.r.
• Perform Op. 5550A10 - STALK UNIT - R.R.
• Perform Op. 7040A26 - STEERING COLUMN PANEL - r.r.
• Perform Op. 5560B10 - ANALOG INSTRUMENT PANEL - r.r.
• Perform Op. 7065C54 - RADIO COMPARTMENT - R.R.
• Perform Op. 7005M10 - WINDOW WINDER CONTROL SWITCH (ONE) OF A FRONT DOOR, LH OR RH, - R.R.
• Perform Op. 7065C10 - AIR CONDITIONING CONTROL PANEL - R.R.
• Perform Op. 7040A37 - FUSE COVER ON INSTRUMENT PANEL - R.R.

(Cont..)