Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Compartment lids › Reassembly
70 BodyworkReassembly

(Op. 7025A22 continued)

DenominationCode
2aRemoving knife1.878.077.000
Diagram showing the removal of a knife (2a) from a soundproofing trim, with a windscreen washer pipe (1) and guide (2b) visible.

Reassembly

  • Assemble the soundproofing trim and place the snap fasteners.
  • Connect the windscreen washer pipe.

7025A26 - BONNET RELEASE - REPAIR

Removal

  1. Unloose the bonnet lid unlocking link (1a)and withdraw the cable(1b).
Diagram showing the bonnet lid unlocking link (1a) and cable (1b) being removed from the bonnet latch mechanism.
  • Carry out Op. 7040A37 - CAP FOR FUSE ACCESS ON DASH PANEL- S.R.
  1. Release the flexible control from the guide(1a) and from the clamps, press on tabs and remove the bonnet release(1b)from its seat.
Diagram showing the bonnet release handle (1b) being pulled from its seat, with the flexible control guide (1a) visible.

Reassembly

  • Position the bonnet release in the proper seat from the passenger compartment.
  • Fasten the link to the lock through the proper screw.
  • Lock the clamps again.
  • Complete with Op. 7040A37 - CAP FOR FUSE ACCESS ON DASH PANEL - R.R.

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.