Refitting

(Op. 7030H14 continued)

1. Apply a butyl sealing cord along the hood perimeter.

Refitting

• Position the hood in its seat.
• Assemble the clamping section bars and tighten the nuts.
• Complete with Op. 7040H16 -ROOF PANEL TRIM FOR MODELS WITH SUNROOF - R.R.
• Complete with Op. 7030H28 - HOOD SLIDING MOTOR PROTECTION - R.R.
• Complete with Op. 7055A62 - ONE PILLAR MOLDING, lh or rh - R.R.
• Complete with Op. 7040E10 - FRONT COURTESY LAMP R.R.
• Complete with Op. 7065C68 - REAR VIEW MIRROR - R.R.
• Complete with Op. 7065C34 - SUNSCREEN VISOR (one), lh or rh - R.R.
• Carry out Op. 7065C30 - Passenger compartment HANDLE (one), lh or rh - R.R.

7030H15 - HOOD CANVAS R.R.

Stacco

• Carry out Op. 7065C30 - Passenger compartment HANDLE (one),lh or rh - R.R.
• Carry out Op. 7065C34 - SUNSCREEN VISOR (one), lh or rh - R.R.
• Carry out Op. 7065C68 - REAR VIEW MIRROR - R.R.
• Carry out Op. 7040E10 - FRONT COURTESY LAMP R.R.
• Carry out Op. 7055A62 - ONE PILLAR MOLDING, lh or rh - R.R.
• Carry out Op. 7030H28 - HOOD SLIDING MOTOR PROTECTION- R.R.
• Carry out Op. 7040H16 -ROOF PANEL TRIM FOR MODELS WITH SUNROOF - R.R.
• Partly open the hood.
• Carry out Op. 7030H12 - HOOD SLIDING MOTOR - R.R. - Operation following electrical equipment check.

1. Unscrew the two nuts (1a) of the pins (1b) which fasten the rear part of the canvas structure.

1. Lift the canvas covering rear part, unscrew the screws (1b), extract the clamps from the limit stops(1c), completely remove the canvas covering(1a) from the guides.

Reassembling

• Place the hood canvas on the car.
• Place the limit stop clamps and fasten them with clamping screws.
• Screw the nuts of the pins which fasten the canvas covering rear part.
• Complete with Op. 7030H12 - HOOD SLIDING MOTOR - R.R. - operation following electrical equipment check.

(Cont..)