E01 Clutch does not disengage correctly
- Make
- Fiat
- Model
- Seicento Factory Service Manual
- Year
- 1998–2010
- Section
- Clutch › E01 Clutch does not disengage correctly
DiagnosisE01 Clutch does not disengage correctly
E01 Clutch does not disengage correctly
Sticking or noise is noted when shifting to lower gear or engaging reverse gear
| Step | Validity Operation to be performed | Test results | ||
|---|---|---|---|---|
| All OK | Problems found | Intervention | ||
| 1 | CHECK CLUTCH PEDAL Check clutch pedal stroke |
Go to Step 2 | Incorrect pedal stroke | Restore clutch pedal operation PROCEDURE OP. 3330B |
| 2 | CHECK CLUTCH PLATE Check: |
Go to Step 3 | Faulty clutch plate or pressure plate | Replace clutch plate PROCEDURE OP. 1810A20 |
| 3 | CHECK GROOVED HUB Check for dirt, rust or dents on the grooved part of the clutch plate hub and gearbox primary shaft |
Go to Step 4 | Faulty gearbox primary shaft hub | Eliminate any damage and clean the hub and primary shaft grooves. If required, replace clutch plate PROCEDURE OP. 1810A20 or the gearbox primary shaft PROCEDURE OP. 2110B32 |
| 4 | CHECK FLYWHEEL Check the flywheel is intact (in particular, check surface conditions and that there are no signs of overheating) |
Go to Step 5 | Damaged flywheel | Replace the flywheel PROCEDURE OP. 1024B22 |
| 5 | CHECK CORRECT OPERATION Check the fault is no longer present |
End of test | – | – |
Parts & tools for this job For 1998 Fiat Seicento
- PARTClutch kitSearch: Fiat Seicento 1998 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Fiat Seicento manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.