Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)13 · Tests
13 · General

Subgroup contents

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Engine › Subgroup contents
TestsSubgroup contents

Subgroup contents

  • - WARNINGS
  • - IMPORTANT NOTES
  • - UNIT TESTS

Units contents

Grp.DescriptionValidity
1056ASingle-Point Injection Power Supply (SPI)

WARNING

The engine compartment contains many parts in motion, components at high temperatures and live electric cables. Scrupulously follow these precautions when working on the engine compartment:

  • Switch off the engine and wait for it to cool.
  • Do not smoke
  • Do not use naked flames.
  • Make sure that there is a fire extinguisher nearby.

WARNINGS

When reassembling, always replace seal gaskets, oil seal rings, spring washers, safety plates, self locking nuts and all deteriorated parts.

1056A - SINGLE-POINT INJECTION (SPI) POWER SUPPLY

List of unit tests

TestDescriptionValidity
AElectric injector operation check
BConstant idle actuator operation check
CIntake air temperature sensor operation check
DThrottle position sensor operation check with manual control1108 899 of throttle case
EThrottle position sensor operation check electronic control899 of throttle case with
FEngine coolant temperature sensor operation check
GFuel consumption check

UNIT TESTS

A - ELECTRIC INJECTOR OPERATION CHECK

  • Disconnect the battery negative (-) terminal.
  • Disconnect the injector electrical connection.
NameCode
Electric injectorN71
  • Use a tester to check that the electric injector winding resistance corresponds to the specified value.
MeasurementValue
Winding resistance electric injector (Ω)at 20 °C 1.75±5%

B - CONSTANT IDLE ACTUATOR OPERATION CHECK

  • Disconnect the battery negative (-)terminal.
  • Disconnect the constant idle actuator electrical connection.
NameCode
Constant idle actuatorN74
  • Use a tester to check that the resistance between the terminals of the constant idle actuator corresponds to the specified values.

(Cont..

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.