Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Stilo Factory Service Manual (2001-2007)22 · Fault diagnosis
22 · Diagnostics

Alarm siren not working

Make
Fiat
Model
Stilo Factory Service Manual
Year
2001–2007
Section
Alarm › Alarm siren not working
Fault diagnosisAlarm siren not working

ALARM SIREN NOT WORKING

When the alarm is activated, the system goes on/off correctly (visual signals and deterrent led activation working) but siren does not go off. Furthermore, with the alarm on, an intrusion attempt is indicated only by the flashing of the turn signals, without an accompanying acoustic signal from the siren.

The alarm system is managed by the body computer node, which controls the acoustic signal siren.

Results of the tests
0CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Connect the diagnostic equipment to the body computer node and check that the alarm system configuration has been correctly programmed while in parameter mode.Continue to Step 1Alarm siren control unit absent.Check car compliance.
1CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Keep the Examiner connected and check for errors in the antitheft siren control unit.Continue to Step 2Error found: siren anomalyCheck that the connector on the antitheft siren control unit is correctly connected.
A-Bus serial line with open circuit.Restore A-Bus serial line continuity/insulation See E7015 ALARM
2CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Keep the Examiner connected and carry out active diagnosis on the antitheft siren control unit.Continue to Step 3Antitheft siren control unit not working.Change the antitheft siren control unit (Op. 5580E46)
3CHECKING CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisFault persists

Change the body computer node (Op. 5505A32)

Search for the fault starting from another symptom'

Parts & tools for this job For 2001 Fiat Stilo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.