Passenger side temperature adjustment does not work
- Make
- Fiat
- Model
- Stilo Factory Service Manual
- Year
- 2001–2007
- Section
- Climate control › Passenger side temperature adjustment does not work
‹ Prev Climate control recirculation not workingNext › Electric air preheating is not activated with low external temperature()
Fault diagnosisPassenger side temperature adjustment does not work
PASSENGER SIDE TEMPERATURE ADJUSTMENT DOES NOT WORK
When the required temperature is set on the passenger side, no air flow is felt at the required temperature
| Results of the tests | ||||
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|---|---|---|---|
| Connect the Examiner, check for errors on the passenger side air mixing motor | Continue to Step 2 | Air mixing motor not working | Continue to Step 3 | |
| 2 | CHECKING USING TESTER | All OK | Problems met | Operation |
| Keep the Examiner connected and check air mixing motor operation using active diagnosis. Restore electrical connection continuity/insulation. | Continue to Step 7 | Air mixing motor does not work | Continue to Step 3 | |
| 3 | CHECKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
| Check continuity/insulation of the electrical connection between climate control Node and passenger side air mixing motor See E6020 AIR CONDITIONING | Continue to Step 4 | Elecrical connection broken or not insulated. | Restore electrical connection continuity/insulation See E6020 AIR CONDITIONING | |
| 4 | CHECKING AIR MIXING MOTOR OPERATION | All OK | Problems met | Operation |
| Disconnect the electrical connector on the air mixing motor side and check for a command signal from the climate control system Node. See E6020 AIR CONDITIONING | Continue to Step 5 | Signal absent | Continue to Step 7 | |
| 5 | CHECKING AIR MIXING MOTOR FLAP | All OK | Problems met | Operation |
| Check that the air mixing motor flap moves through its travel without sticking. | Continue to Step 6 | Flap blocked or damaged | Release the air recirculation motor flap from its block or replace the flap if damaged. | |
| 6 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | The fault persists | Change the passenger side air mixing motor [PR.5040D86]. | |
| 7 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | The fault persists | Change the climate control system nodeOp. 5040D18 Search for the fault starting from another symptom' | |
‹ Prev Climate control recirculation not workingNext › Electric air preheating is not activated with low external temperature()
Parts & tools for this job For 2001 Fiat Stilo
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Fiat Stilo 2001 cabin filter
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.