Luggage compartment does not open with remote control

Make: Fiat
Model: Stilo Factory Service Manual
Year: 2001–2007
Section: Doors › Luggage compartment does not open with remote control

‹ Prev Central locking / not working with remote control Next › Doors / boot open buzzer not present with car in motion

Fault diagnosisLuggage compartment does not open with remote control

LUGGAGE COMPARTMENT DOES NOT OPEN WITH REMOTE CONTROL

When opening is controlled by means of the remote control unit, the boot lid does not open.

The boot lid opening command is received by the Body Computer Node via the internal radio aerial; the Body Computer Node releases the boot lock and releases is slightly, thus disabling the alarm (if present). When the door lock is disengaged, the boot lid opens to operate the electric handle on the bonnet. In 'independent boot' mode, boot lid opening is implemented by means of a remote control unit or dowel on the mechnical key.

0	PRELIMINARY CHECK	All OK	Problems met	Operation
		Results of the tests
	Check the condition of the boot lock/release fuse.	Continue to Step 1	Fuse blown	Change the fuse
1	PRELIMINARY CHECK	All OK	Problems met	Operation
	Check remote control unit battery charge status	Continue to Step 2	Battery charge status insufficient	Change the remote control battery
2	PRELIMINARY CHECK	All OK	Problems met	Operation
	Check system operation using the second remote control unit supplied with the car.	Continue to Step 3	The fault persists	Continue to Step 4
3	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner) and check the defective remote control unit correctly stored in the Body Computer Node configuration.	Continue to Step 14	Remote control unit not stored in the Body Computer Node configuration.	Store the remote control unit (see Description and Operation).
4	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner and ensure the remote control units are stored in the Body Computer Node configuration.	Continue to Step 5	Remote control units not stored in Body Computer Node configuration.	Store the remote control units (see Description and Operation
5	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check individual remote control keys are properly downloaded and operational while in parameter mode.	Continue to Step 6	Remote control unit signals have not been properly downloaded.	Continue to Step 10
6	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check for errors in the Body Computer Node.	Continue to Step 7	Errors found: boot opening control relay short-circuited or circuit open.	Change the boot lid opening relay.
7	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Use active diagnosis to check boot lid opening	Continue to Step 13	Boot lid does not open	Continue to Step 8
8	CHECKING ELECTRICAL CHECK CIRCUIT USING DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Check the electrical connection between the Body Computer Node and the boot lid catch. Use active diagnosis to check boot lid opening.	Continue to Step 9	Electrical connector on boot lid handle not correctly connected.	Connec the electrical handle to the boot lid handle correctly
		Continue to Step 9	Connection broken or not insulated.	Restore continuity/insulation of the electrical connection See E3045 BOOT AND FUEL FLAP OPENING
9	CHECKING ELECTRICAL SIGNAL	All OK	Problems met	Operation
	Disconnect the boot lid electrical connector and check for a opening command signal.	Continue to Step 12	Opening command signal absent.	Continue to Step 13
10	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Use an Examiner to check for errors.	Continue to Step 13	Error found: radio receiver faulty.	Continue to Step 11
11	CHECKING ELECTRICAL CIRCUIT	All OK	Problems met	Operation
	Check the radio receiver aerial	Continue to Step 13	Connected the incorrectly connected aerial to the radio receiver	Connect the aerial connect to the Body Computer Node correctly.
	Check the radio receiver aerial	Continue to Step 13	Radio receiver aerial broken	Change the radio receiver aerial.
12	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Change the boot lid lock Op. 7025B38
13	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Change the Body Computer Node Op. 5505A32
14	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present		The fault persists	Change the remote control unit Search for the fault starting from another symptom'

‹ Prev Central locking / not working with remote control Next › Doors / boot open buzzer not present with car in motion

Parts & tools for this job For 2001 Fiat Stilo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.