Verifiche sulla barra stabilizzatrice

Check 4410CA

Position the vehicle on a two column lift.

Raise the vehicle and check that the anti-roll bar is (transversely) correctly positioned in relation to the centre line.

1. Check that there is no wear of the paint at the contact points between the bar and the crossmember (1a) and between the bar and the shock absorbers (1b).

2. Using a torque wrench calibrated at the recommended figure, check that the fastenings between the bar and the crossmember (2a) and between the bar and the shock absorber mounting connecting rods (2b) are tightened to torque.

2a. M8 Bolt (on crossmember): 2.5 daNm

2b. M10 x 1.25 Nut (on shock absorber mounting connecting rod): 5 daNm