RIGHT UPPER LAMBDA SENSOR R R

Operation 1080B93 · EXHAUST EMISSION CONTROL SYSTEM

3.0 24V V6

Removing

- Position the vehicle on the lift.

- Disconnect the negative battery terminal.

Op. 5010B18 CLIMATE CONTROL UNIT AIR INTAKE - R.R.

Op. 5050B34 WINDSCREEN WIPER ARM/S COMPLETE WITH BLADE - R+R

Op. 7210E22 WINDSCREEN BASE TRIM

See in Op. 1088B10

Op. 1016A42 LEFT HAND CYLINDER HEAD IGNITION COIL COVER - R+R

Op. 4410D16 BRACKET (ONE) RETAINING CHASSIS TO BODY - R R

Op. 7055B54 UNDER-ENGINE GUARD - R R

1. Working on the right head, timing side, disconnect the electrical connection (1a) for the upper Lambda sensor and move the wiring then release the connector (1b) from the mounting bracket.

2. Undo the upper Lambda sensor from the right exhaust manifold and remove it

Refitting

- Fit the upper Lambda sensor on the right exhaust manifold and tighten it to the recommended torque.

- Position the connector on the mounting bracket.

- Connect the electrical connection for the upper right Lambda sensor and secure the wiring.

Op. 7055B54 UNDER-ENGINE GUARD - R R

Op. 4410D16 BRACKET (ONE) RETAINING CHASSIS TO BODY - R R

Op. 1016A42 LEFT HAND CYLINDER HEAD IGNITION COIL COVER - R+R

See in Op. 1088B10

Op. 7210E22 WINDSCREEN BASE TRIM

Op. 5050B34 WINDSCREEN WIPER ARM/S COMPLETE WITH BLADE - R+R

Op. 5010B18 CLIMATE CONTROL UNIT AIR INTAKE - R.R.

- Connect the negative battery terminal.

Op. 0010T21 COOLANT CHECK DENSITY AND TOP UP IF NECESSARY

- Remove the vehicle from the lift.