ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Water Pump - 1.8L Endura-DE (Kent) Diesel > < Cooling Fan Motor

Fiesta 1996 (08.1995-02.2002)

Engine Cooling - Radiator—1.8L Endura-DE (Kent) Diesel Fiesta 1996 (08/1995-02/2002)
Removal and Installation

Removal

All vehicles
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Drain the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

  1. Disconnect the radiator hoses.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the lower air deflector (if equipped).

  1. Disconnect the fan multiplug and unclip the wiring loom.

  1. Detach the multiplug from the radiator support.

  1. Disconnect the lower radiator hose.
Vehicles with air conditioning
  1. Detach and secure the air conditioning condenser from the radiator.
All vehicles
  1. Support the radiator assembly and remove the four support retaining bolts (left-hand side shown).

  1. Remove the fan and radiator assembly complete.
  1. If the radiator is to be renewed, remove the fan assembly.

Installation

  1. To install, reverse the removal procedure.
  1. Refill the cooling system and check for leaks.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

Water Pump - 1.8L Endura-DE (Kent) Diesel > < Cooling Fan Motor