ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Torque Converter > < Transaxle Case

Focus 1999 (08.1998-12.2004)

Automatic Transmission/Transaxle - Vehicles With: 4F27E - Main Control Valve Body Focus 1999 (08/1998-12/2004)
Disassembly and Assembly of Subassemblies

Disassembly

 
Item
Part Number
Description
1
-
Valve assembly - manual control
2
-
Plate - spring retainer (7)
3
-
Spring - bypass clutch control (4)
4
-
Valve - bypass clutch control (2)
5
-
Spring modulation valve
6
-
Valve - line pressure modulator (and converter relief) (2)
7
-
Bolt M6x40 (3)
8
-
Bolt M6x30 (5)
9
-
Seal - valve body
10
-
Bolt M6x60 (5)
11
-
Body - control valve upper
12
-
Gasket/plate assembly - control valve body
13
-
Gasket - control body separator
14
-
Body - control valve lower
15
-
Stop - main regulator valve
16
-
Retainer plate - main regulator valve
17
-
Spring - main fluid pressure regulator valve
18
-
Valve - main fluid pressure regulator
19
-
Spring - solenoid regulator valve
20
-
Valve - solenoid regulator valve
21
-
Spring - intermediate servo accumulator
22
-
Piston - intermediate servo accumulator
23
-
Spring - converter regulator valve
24
-
Valve - lock up control and 3-4 shift (2)
25
-
Gasket - solenoid body
26
-
Solenoid - shift control (2)
27
-
Solenoid assembly - electrical pressure control
28
-
Screw M6x15 (7)
29
-
Screw M6x72 (2)
30
-
Body - solenoid shift throttle pressure
31
-
Solenoid assembly - shift control (3)
32
-
Bracket - shift control solenoid H/DWN
  1. Remove the solenoid body bolts and the solenoid body.

  1. Remove and discard the solenoid body gaskets.

  1. Remove and discard the seals.

  1. Disassemble the main control valve body.

Assembly
  1. NOTE:
    NOTE:The top side of the separator plate has a bonded gasket.
    NOTE:
    NOTE:The separator gasket goes on the bottom side.
    NOTE:
    NOTE:Inspect the main control valve body.
    Install new control valve body plate assembly and separator gaskets.

  1. NOTE:
    NOTE:Do not fully tighten the bolts at this stage.
    Assemble the main control valve body.

  1. Install the seals.

  1. Tighten the solenoid body bolts.

  1. Tighten the remaining bolts in the sequence shown.

Torque Converter > < Transaxle Case