Installation and Testing Precautions

Installation and Testing Precautions

WARNING: The integrity of SRS system components are critical for safety reasons. Ensure the following precautions are always adhered to: • Never install used SRS components from another vehicle or attempt to repair an SRS component. • When repairing an SRS system only use genuine new parts. • Never apply electrical power to an SRS component unless instructed to do so as part of an approved test procedure. • Special Torx bolts are necessary for installing the airbag assembly - do not use other bolts. Ensure bolts are tightened to the specified torque (refer to SRS section). • Ensure that SRS component fixings are correctly positioned and torqued during service and repair. • Always use new fixings when replacing an SRS component. • Ensure the SRS Diagnostic Control Unit (DCU) is always installed correctly. There must not be any gap between the DCU and the bracket to which it is mounted. An incorrectly mounted unit could cause the system to malfunction.

• The SRS Diagnostic Control Unit is a non-serviceable component and no attempt should be made to repair or modify the unit. • Do not try to disassemble the airbag assembly. It has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused. • If you suspect an airbag assembly could be defective, install a new unit and dispose of the old unit. Manually deploy the old unit before disposal. See SRS Precautions.

WARNING: When removing, testing or installing an airbag module do not lean directly over it.