LR3/Disco 3
Transmission Fluid Level Check (44.24.06)
1 . The following steps must be observed before starting the transmission fluid level check and top-up.
2 .
Connect T4 to the on-board diagnostic connector to monitor the transmission fluid temperature.
3 . Start the engine. Move the selector lever from 'P' through all gear positions, pausing in each gear position for 2-3
seconds and return to the 'P' position.
4 .
Raise and support the vehicle.
5 . Remove the transmission undershield.
Published : Dec 2, 2004
WARNING: Observe due care when draining transmission fluid as the fluid can be very hot.
WARNING: Observe due care when working near a hot exhaust system.
CAUTION: The gearbox fluid level must only be checked when the temperature of the fluid is between 30
degrees and 50 degrees. The fluid level obtained will be incorrect if the reading is outside this temperature
range.
The vehicle must be on a horizontal ramp.
The parking brake must be applied.
The wheels must be chocked.
CAUTION: Make sure the transmission fluid temperature is below 30 degrees before starting the fluid
level check.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on
safety stands.
Remove the 6 bolts.