LR3/Disco 3
Blower Motor (82.26.33)
Removal
Installation
Published : Jul 1, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the LH C-pillar lower trim panel For additional information, refer to
C-Pillar Lower Trim
Panel (76.13.34)
(Section 501-05)
3 .
NOTE :
Note the fitted position.
Remove the blower motor.
Disconnect the electrical connector.
Remove the 3 screws.
1 .
Install the blower motor.
Tighten the screws.
Connect and secure the electrical connector.
2 .
Install the C-pillar lower trim panel. For additional information, refer to
C-Pillar Lower Trim Panel
(76.13.34)
(Section 501-05)
3 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-00)