B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
15. Install a new gasket and separator.
NOTE:
^
Make sure main control to case gasket is properly aligned.
^
Use petroleum jelly to hold gasket in place.
16. Install the control valve body assembly.
1) Position the assembly using the SSTs as a guide.
NOTE: The main control valve body bolts will be tightened in later steps.
2) Loosely install the four M6x45mm main control valve body bolts.
3) Loosely install the two M6x35mm main control valve body bolts.
4) Remove the SSTs.
