B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
6. Remove the transmission fluid filter.
7. Remove main control valve body wire loom.
-
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.
8. Disconnect the solenoid electrical connectors.
1) Disconnect the SS1, SS2, SS3 and the CCS/SS4 electrical connectors.
2) Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3) Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
CAUTION:
^
The TCC solenoid and converter modulator valve may pop out of its bore. This may damage the solenoid or converter modulator valve.
^
Shift solenoids may pop out of their bore. This may damage the solenoids.
9. Remove the EPC and SS2 solenoids.
1) Remove the solenoid clamp bolts.
2) Remove the solenoid clamp.
3) Remove the EPC and SS2 solenoids.
CAUTION: Do not pry on the other wires or damage the connector case surface.
