B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
10. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector from the transmission case (16 pinch) electrical connector.
1) Disconnect the TSS sensor electrical connector.
2) Remove from the TSS sensor wire locator.
CAUTION: Do not overstretch the retaining spring.
11. Remove the transmission case (16 pinch) electrical connector retaining spring.
CAUTION: Do not damage the connector or harness.
12. Remove the transmission case (16 pinch) electrical connector.
1) Compress the tabs on the transmission case (16 pinch) electrical connector.
13. Push the transmission case (16 pinch) electrical connector out of transmission case.
INSTALLATION NOTE
NOTE:
-
Make sure the tab is in the lock position.
^
Install new O-rings on the transmission case (16 pinch) electrical connector.