B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Note:
^
Apply petroleum jelly on the valve body separator plate to hold the main control to case gaskets in place.
^
Use new separator plate main control to case gaskets on installation.
10. Install the main control valve body separator plate and main control to case gasket.
1) Position the main control valve body separator plate to the main control to case gasket and install separator plate to main control valve body.
2) Install, do not tighten, the separator plate screws.
11. Install Valve Body Alignment Pin SSTs 49 UN01 139 and 49 UN01 140 into the main control valve body.
1) Install large Valve Body Alignment Pin SST 49 UN01 140 (0.248 DIA).
2) Install small Valve Body Alignment Pin SST 49 UN01 139 (0.235 DIA).
12. Tighten the separator plate screws.
13. Install new main control to case gasket.
Note:
^
Apply petroleum jelly on the separator plate surface to hold the gaskets in place.
^
Use new separator plate gaskets on installation.
