B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
14. Remove the Valve Body Alignment Pin SSTs 49 UN01 139 and 49 UN01 140 from main control valve body.
1) Remove large Valve Body Alignment Pin SST 49 UN01 140.
2) Remove small Valve Body Alignment Pin SST 49 UN01 139.
15. Rotate the main control valve body so the valve body separator plate is facing down.
Caution: All solenoid electrical connectors must face upward on installation.
16. Install the SS2, CCS (4R44E only), SS4 (5R55E only), TCC and EPC solenoids.
1) Install the TCC solenoid.
2) Install the SS2 and CCS or SS4 solenoids.
3) Install the EPC solenoid.
Note:
^
All shift solenoids are interchangeable.
^
If the TCC valve came out during disassembly, use caution when installing the torque converter clutch solenoid.
Caution: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
17. Install the solenoid clamp and the solenoid clamp bolt.
1) Position the solenoid clamp on the main control valve body
2) Install the solenoid clamp bolt.
Caution: The shift solenoid electrical terminals must face up on installation.
18. Install the SS1 and the SS3 shift solenoids.
Note: The shift solenoids are interchangeable.
