Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)10 · Heating and air conditioning
10 · Heating & A/C

Refrigerant charging (page 5 of 9)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Refrigerant System
Heating and air conditioningRefrigerant charging · page 5 of 9

seriously injure you. Therefore, do not open the high-pressure side valve while the engine is running.

  1. Open the low-pressure side valve of the manifold gauge.
HVAC – Refrigerant System – figure
Fig. 6: Connecting Manifold Gauge Set
Courtesy of MAZDA MOTORS CORP.
  1. When the high-pressure side reading increases to 98 kPa {1.0 kgf/cm2 , 14 psi} , close the low-pressure side valve of the manifold gauge.
  2. Inspect for leakage from the cooler pipe/hose connections using a gas leak tester.
    • If there is no leakage, go to Step 18.
    • If leakage is found at a loose joint, tighten the joint, go to next step.
  3. Inspect for leakage again.
    • If there is no leakage after tightening the joint, go to next step.
    • If there is still a leakage at the same joint, discharge the refrigerant and then repair the joint. Repeat the charging procedure from Step 7.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.