Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)10 · Heating and air conditioning
10 · Heating & A/C

Refrigerant charging (page 8 of 9)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Refrigerant System
Heating and air conditioningRefrigerant charging · page 8 of 9
HVAC – Refrigerant System – figure
Fig. 9: View Of High & Low-Pressure Side Manifold Gauge Set
Courtesy of MAZDA MOTORS CORP.
  1. Start the engine and actuate the A/C compressor.
  2. Open the low-pressure side valve of the manifold gauge and charge with refrigerant until the weight of the refrigerant tank has decreased 450 g {15.9 oz} from the amount in Step 13.
  3. Close the low-pressure side valve of the manifold gauge and the valve of the refrigerant tank.
  4. Stop the engine and A/C compressor.
  5. Inspect for leakage using a gas leak tester.
    • If there is no leakage, go to Step 26.
    • If leakage is found at a loose joint, tighten the joint, then go to next step.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.