Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Connector Terminal Check Method

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Connector Terminal Check Method
SuspensionConnector Terminal Check Method

NOTE: If engine starts and runs, perform the following steps at idle.

  1. Access PIDs for the switch you are inspecting.
  2. Vibrate the sensor slightly with your finger.
    • If PID value is unstable or malfunction occurs, check for poor connection and/or poorly mounted sensor.

Connector Terminal Check Method

  1. Check the connection condition of each female terminal.
  2. Insert male terminal; fit the female terminal side to female terminal and check to see whether the malfunction is in the female terminal or not.
SUSPENSION – Symptom Troubleshooting – figure
Fig. 4: Checking Connection Condition Of Female Terminal
Courtesy of MAZDA MOTORS CORP.

SYMPTOM TROUBLESHOOTING

SYMPTOM TROUBLESHOOTING CHART

No.

Symptom

1 TPMS warning light illuminates continuously.

TPMS warning light (low pressure warning) illuminates after engine start and turns off after driving

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.