Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Foreword

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Foreword
SuspensionForeword
SUSPENSION – Symptom Troubleshooting – figure
Fig. 2: Tire Pressure Monitoring System (TPMS) Wiring Diagram (Without Advanced Keyless System
And Keyless Entry System)
Courtesy of MAZDA MOTORS CORP.

FOREWORD

  • Before performing the steps in Symptom Troubleshooting, perform the On-board Diagnostic Inspection. To check the DTC, follow the DTC Inspection steps. (See DTC TABLE .)

PRECAUTION

INTERMITTENT CONCERN TROUBLESHOOTING

Vibration Method

  • If malfunction occurs or becomes worse while driving on a rough road or when the engine is vibrating, perform the steps below.

NOTE: There are several reasons why vehicle or engine vibration could cause an electrical malfunction. Some of the things to check for are:

Connectors not fully seated.

Wire harnesses not having full play.

Wires laying across brackets or moving parts.

Wires routed too close to hot parts.

  • An improperly routed, improperly clamped, or loose harness can cause wiring to become pinched

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.