EPAS ECU connector C0316 pin details (Steering)
- Make
- MG
- Model
- MGF Factory Workshop Manual
- Year
- 1995–2000
- Section
- Description and operation › EPAS ECU connector C0316 pin details
SteeringEPAS ECU connector C0316 pin details
EPAS ECU connector C0316 pin details
| Pin No. | Description | Input/Output |
|---|---|---|
| 1 | Clutch earth | Input |
| 2 | EPAS instrument pack warning lamp | Output |
| 3 | Not used | - |
| 4 | Torque sensor earth | Input |
| 5 | Torque sensor | Input |
| 6 | Torque sensor 5V supply | Output |
| 7 | Road speed signal | Input |
| 8 | Ignition ON signal | Input |
| 9 | Clutch 12V supply | Output |
| 10 | Not used | - |
| 11 | Not used | - |
| 12 | EPAS1 - Potentiometer earth EPAS2 - Not used | EPAS1 Input |
| 13 | Torque sensor | Input |
| 14 | EPAS1 - 12V supply for potentiometer EPAS2 - Not used | EPAS1 Output |
| 15 | Engine speed | Input |
| 16 | Diagnostic socket | Input/Output |
CAUTION: On EPAS2 vehicles, the potentiometers are connected in series, therefore, pins 12 and 14 are not used. Wires are still present in harness connector but are unterminated in the torque sensor. DO NOT short circuit either of these pins.
Parts & tools for this job For 1995 MG MGF
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: MG power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.