Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual19 · EL - Electrical System
19 · Electrical

Installation and Adjustment - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › Installation and Adjustment - Nissan 200SX S12 Workshop Manual
EL - Electrical SystemInstallation and Adjustment - Nissan 200SX S12 Workshop Manual

Installation and Adjustment

HEADLAMP Assembly

Installation and Adjustment

Set the headlamp motor to “CLOSE” position. . i Install headlamp bracket to body temporarily Connect harness to headlamp motor and set and check right-left alignment. retract switch to “CLOSE”. Headlamp motor YW Cover headlamp bracket with lid and turn

can now be set to “DOWN” with retract

motor manual knob to close headlamp. switeh. Before doing this, be sure to disconnect hat

Assemble headlamp motor to the headlamp

tery ground cable. bracket. 2) Determine headlamp bracket location on body

j. Assembie the link A to the headlamp motor so that rightleft alignment between lid, hood, as shown below. and fender is as shown below.

SELI068 ‘Angring mark for

“CLOSE” position

. Assemble link B to link A and the headlamp 3 After adjusting right-left alignment, remove bracket, lid and tighten headlamp bracket securely to If the lock nut on link B has been loosened, body. ‘ confirm that link B is the length shown below, then tighten lack nut firmly. Adjust stopper. n Loosen lock nut on stopper, 2) Turn motor manual knob to open headlamp. assembly completely. 3) Adjust stopper screw.

Motor tide seLia7e

SeLTa9

EL-56

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.