METER AND GAUGES —| - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › METER AND GAUGES —| - Nissan 200SX S12 Workshop Manual
METER AND GAUGES —|
METER AND GAUGES —|
ital Type
Troubl
shooting Flow Chart —Multiple Gauges— (Cont‘d)
44, ONLY WATER TEMP, GAUGE WILL
13.
FUEL GAUGE DOES NOT REACH
“FULL”
NOT FUNCTION
Check if all sagments of fuel gauge light up when uel Make pre-programed signal check. tank is Filled with Fuel. (Refer to “Self-Check”.) a OK. ves] y No No trouble | Make segment cheek. (Rete to “"Salt-chack’) Auplace control Ox. unit. . la
Moature resistance of fuel tank | Replace Go to “Thermal Transmitter Check”. gwuge uit. dlgplay unit ox] OK, ] Tse. | ms. Replace control ‘Check tuel tank unit.
‘gauge unit
Check harness Replace between meter and ‘thermal transmitter, thermal transmitter, (1) Turn ignition switch OFF, {2} Remove combination meter.
18. ONLY OIL PRESSURE GAUGE WILL
(3) Disconnect harness connector from control
NOT FUNCTION
unit. (4} Measure resistance between terminals «3 Make pre:programed signal check. and (Refer to “Self-Check”,) Control unit ox. NG. Replace control unit.
‘Onenmator Go to “Oil Pressure Sending Unit Check”. ie) on] iC a oil) Fiomaining fuel | Rvivtance ‘Check harness between Replace oil pressure meter and oil pressure sending unit. Full ank | Less then 260 ea dita sending unit,
EL-76
Parts & tools for this job For Nissan 200SX
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.