METER AND GAUGES — - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › METER AND GAUGES — - Nissan 200SX S12 Workshop Manual
METER AND GAUGES —
METER AND GAUGES —
ital Type
Trouble-sheoting Flow Chart —Speedometer— {Cont'd}
4. ALL SEGMENTS BECOME ILLUMINATED
8. SOMETIMES INDICATES ZERO
display unit check, (Refer While making pre-progremed signal elf Check") check, lightly tap on control unit and display unit with screwdriver to see if display changes. OK, | NG. Replace control unit.
Check harness between Go to “Power Unit Check" ta check powor unit eutput mater and speed sensor. Voltage for display.
(Between terminal END) and Gow) )
ox. | sal ne Replace speed Replace control sensor. uit. Replace display Replace power unit. unit. (1) For pre-programed signal check procedure, refer to “Self-Check”’. {2) Lightly tap on corners of control unit and display unit with screwdriver. (3) If no change occurs, tachometer circuit is
5. ALL SEGMENTS FAIL T@ ILLUMINATE
in good order. Moke display unit chock. (Refer
NG. Replace control unit.
Go to “Power Unit Check” to check power unit output voltage for speedometer.
(Between tarminais CED and ED)
3 | . [r= SEL2I48 Replace display Replace power nit, unit.
EL-73
Parts & tools for this job For Nissan 200SX
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
As an Amazon Associate we earn from qualifying purchases.