Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual19 · EL - Electrical System
19 · Electrical

— Installation and Adjustment —__ - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › — Installation and Adjustment —__ - Nissan 200SX S12 Workshop Manual
EL - Electrical System— Installation and Adjustment —__ - Nissan 200SX S12 Workshop Manual

— Installation and Adjustment —__

HEADLAMP

— Installation and Adjustment —__

Aiming Adjustment

(Cont'd) When performing headlamp aiming adjustment, use

3. Adjust lid alignment, an aiming machine, aiming wall screen or headlamp. ¢ Adjust tid, hood and fender for atignment tester. For operating instructions of any aimer, it while opening and should be in good repair, calibrated and used ac- closing headlamp with motor manual knob. cording to respective operation manuals supplied with the unit. Use motor manual knob to open and close If any aimer is not available, aiming adjustment can hesdlamp, and adjust alignment while checking be done as follows: ‘that lid is not interfering with protector. For details, refer to the regulations in your own Before starting adjustment, be sure that bat- ‘tery ground cable is disconnected. country,

CAUTION:

8. Keep all tires inflated to correct pressures.

b. Place vehicle and tester on one and same flat surface, ¢, See that thera is ne load in vehicle (coolant, en- gine oil filled up to correct level and full fuel tank) other then tha driver (or equivalont weight placed in dri Wy = 1,087 (42.0)

SELI90E

* Morlaontal conte line of headlamps Vertical conterling Upper aoe of coheed of headlamps ‘high intensity zone vat

_N ‘Adjuse so that cover Ie fla, Too eg a SELIGIE Latch oe ‘ws

(Fo = soverrasLe

nance Unt:

mm tn

sevase0 © Adjust headlamps so that upper edge and left, edge of high intensity zone ara within the a

ceptable range as shown in the figure above,

© Dotted lines in illustration show center of headlamp.

EL-57

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.